- Model Number :DSE5320
- Provides RS232 Modem link to PC via either PSTN line or GSM network (using a suitable modem).
- LCD 4-line text
We are authorized agent
Deep Sea Electronics PLC Can connect to ‘Eco friendly’ engine management systems of electronic engines
providing engine protection and instrumentation without requiring additional senders.
Comprehensive remote communiCAT-parts-partsion via optional RS232 port. Provides RS232 Modem link to PC via
either PSTN line or GSM network (using a suitable modem).
The module can also signal Engineers via their cell phones using the GSM SMS messaging system to
advise of system alarms.
Optional RS485 ‘Modbus’ output. Using industry standard communiCAT-parts-partsion protocol allows full system
integration into new and existing building management and control schemes.
Engine diagnostic information removes the need for both service equipment and cryptic diagnostic lamp
(when used in conjunction with electronic engines).
LCD 4-line text based display to provide ‘at-a-glance’ diagnosis of fault conditions, instrumentation and
operating state. Comprehensive PC configuration and status monitoring using 5xxx PC software.
PIN number protected front panel programming of selected trip points and timers, allows field changes to be
made to the module settings. The Model DSE5320 is an Automatic Mains Failure Control Module.
The module is used to monitor a mains supply and automatically start a standby generator set. The module
also provides indiCAT-parts-partsion of operational status and fault conditions, automatically shutting down the genset
and indiCAT-parts-partsing failures by means of an LCD display, and appropriate flashing LED on the front panel.
Selected timers and alarms can be altered by the customer from the front panel. Alterations to the system
are made using the 810 interface and a PC. This interface also provides real time diagnostic facilities.It is
also possible to monitor the operation of the system either locally or remotely.
Dimensions: 240mm x 172mm x 57mm Panel Cutout: 220mm x 160mm ( 8.7” x 6.3”)
